Knightsbridge 6A DP Inline Cord Switch, White ST6AWH

يصلح للأشياء البسيطة

This is very difficult to wire as others have reported. You have to cut the wires very short - about 6mm This has no proper cable clamp, just the top and bottom of the case and the slot was too narrow for even a 2-core cable. Had to cut away part of the case. One assembled it worked well, but then overnight it failed to switch on. I discovered if you switch off the mains supply at the wall plug and left it a few seconds it started working again, only to fail the same way a few hours later. Not much use for a bedside light in the dark! Don't waste your money!

Good LED dimmer that can go very low with the input power without flickering or noisy LED response. The only remark: the button control is not as user-friendly as a knob.

Ces interrupteurs sont solides et bien construit. Ils disposent de connecteurs a vis pour 3 fils (phase, neutre et terre, mais seuls les fils phase et neutre sont interrompus). les fils sont correctement maintenus à l'arrivée et au départ de l'interrupteur par des petits cavaliers fixés chacun avec 2 vis.

If you put aside the fact that this little dimmer is fairly difficult to wire up .... This dimmer has virtually no allowance for DIMMING .......you can get it half way between fully "ON" and fully "OFF " There is virtually no allowance in between . Perhaps if you have the dexterity of a brain surgeon and the reflexes of a fighter pilot you will disagree with me. ..