DASBET 3 Jaw Inner Bearing Puller Set Blind Bearing Puller Set

Worked well to help me remove a bearing

Yeah sure this is a cheap Chinese tool- but boy, it did the trick! I had a rather large (3” O.D.) bearing in a transfer case that only had 1/8 of an inch clearance behind it; so I had to grind the feet/hooks down quite a bit to get them to fit onto the backside of the bearing. I was worried they would not be strong enough to pull out the bearing. But as thin as as I ground them to, they definitely were still strong enough to pull that large #6009 bearing! This puller is definitely made in the good section of China! Oh yeah, I also had to put a 1/2 inch washer on the cone to spread the legs out far enough to get a good hold of the inside of the inner race.

I got this to pull a bearing in a pipe and it constantly slipped off. This is very cheap and only usable where you have significant even flat surfaces all around the bearing.

If you need a cheap gear puller this one works okay but its oily.

The bearings went out in my GE front load washing machine. I used this to pull the stuck bearings out which were pretty rusted and seized up due to the water and cleaning detergents used. A little patience and oil went went a long way in helping out. I would recommend this blind hole bearing puller, it worked well for me.

I think this is probably a great tool, but does not work for what it was advertised for. I needed to pull a pilot bearing and the tool was too big to fit into the pilot bearing. Check the minimum dimensions that it will collapse to before you decide if it will work for you.

This bearing puller is perfect. Great price and does what it needs to. Make sure you pay attention to the effective sizes of the puller though. Fortunately I had multiple bearings to pull so I needed more than just this puller anyways, any bigger than the recommended size and it quickly becomes useless.

Excelente

Easy to use on stubborn bearings

Lorsque j’en ai eu besoin le Béring est trop petit ça prend quand même un gros diamètre pour pouvoir entrer les trois pattes

Great product, would have given 5 stars but the chrome piece that pushes on the puller legs was a loose fit and would fall off when not in use. This did not affect the performance though.

From a company like Dasbet what did I expect? The casting on the jaws was so poor I immediately had to use a file in order to clean them up enough to even hook onto the bearing I was pulling. Leave these in the scrap bin

Bought this to pull out my motorcycle wheel bearings with a 3/4 inch center hole. Truly a piece of junk and definitely not worth the money. It has three legs on it to grab the bearing, but when I tighten it up one leg would always sit cockeyed. I should’ve spent my money on a slide hammer. I ended up taking the wheel into a motorcycle shop and that’s what they used on it.