I was using slightly cheaper blades but these really seem worth the money. This runs straight and flat and has been cutting brass and aluminum for months.

Muy bien resultado en el corte y es lo suficientemente estable y sólida en baja tensión. Si usted va a comprar una fíjese bien en la caridad de TPIs para que su corte sea el adecuado a la madera que usará. Aún así, en el respaldo de la caja encontrará muchas instrucciones en 3 idiomas para que tenga claro todos esos detalles. Lo recomiendo seguiré comprando la misma marca.

this is my only half inch bandsaw blade. I use it for resawing rough lumber. I have been successful resawing ambrosia maple, walnut, and red oak. Properly tensioned, and with a reasonable feed speed, I get a good cut that I can then clean up with sandpaper in some cases, and a planer if its too much to sand. I don't do enough resawing of hardwoods to predict the lifespan of this blade, but it has already lasted longer than the blade the I used first. Won't say the name of that one though.

This blade is the best I have used on my rikon 10-3061. It is not too agressive so it does not grab the wood like other blades. Also great for resawing because 4 tpi is still plenty. If you use a bandsaw instead of a tablesaw like me, you are going to need a blade that does not wander all over the place. This blade cuts straight at an arrow. I have used over 10 different brands on my saw and this one does the best by far. So, do I recommend this blade, yes I do! As a side note, the finish this blade creates is not bad for a bandsaw.

aparentemente de buena calidad, con la medida esperada y tiempo de netrega tal como lo esperaba.