Knife Thumb Studs for Buck 110 and 112 2pcs With Hex for Pocket Knife EDC

Ok it fits! It's tight! You have to rock it on the blade then tap it down! After I man handled it a little it's on and it's not going to fall off!

I liked the idea of having an extra grip for my fingers to open the blade. It was a tight fit and had to be persuaded to go on the blade. Once on the blade, it provided the grip that was needed, however it did get in the way of the blade when using the knife. So far, I haven’t decided whether I should remove the thumb grip or leave it on.

don't waste your money. will not fit the buck 110 or the buck 112.

Fit on the Buck 110 no problem. Adjustable so you can place in the right spot. Works for one handed opening. Looks good. Only problem is that it catches when I try to put the knife back in the sheath. Have to force knife in. May get better with time?

This is a great product for a folding pocket knife that doesn't have a thumb grip to open. It is tightened with a set screw and works very well. I use it for my Buck 110 folder

I needed some replacement thumb studs, and these fit the bill very well. The only thing to know is that depending on the blade stock thickness you may have to give them a bit of a love tap to get them down onto the top of the blade, but once they’re in there, they’re not going anywhere. Not much else to say other than they seem to be very well machined and well built, and I’ve had these on the knife in question for about six months now and they haven’t budged an inch. Now they’re not crowned or anything like that so they do have a bit of an edge to him, but honestly, it’s nothing to write home about the work good for you.

I can now open my commemorative engraved 112 Buck knife with one hand. The knife still fits in the leather case. It took a little practice opening and also to find the best position. It works fine with my heavy-duty knife. Since it is brass It matches the brass on the knife. It also adds to the look of the knife. It is exactly what the knife needed. It does not slip out of position. It was easy to install. It works best by pushing straight up with the thumb after some practice.

Very well done but, unfortunately, it doesn't fit on my Buck 110, the groove is not wide enough for my Buck 110 blade, I used it on other knives anyway, but not on my Buck 110. I must say the my knife was made in the early 80's, if I remember correctly, and maybe the newest ones have a blade a little more thin, I don't know.

could not mount except close to the tip which defeats the purpose of buying this waste of money does not fit buck 110 model

Me gustó mucho es muy útil y aparte hace lucir muy elegante el cuchillo 🔪 o navaja donde lo vayas a colocar

Se requiere mucha presión para apretarlo y aún así se resbala con el uso

It works but required some filing and fitting work. Arrived within one day BTW. Concern #1: It came with internal slot dimensions smaller than 1/8" of Buck 110 knife blade, so it has required about 10 min of filing to make the slot wider to sit snug on the blade. Concern #2: the external part of the knob would benefit from knurling. Concern #3: When you tighten the screw, the stud can slide off the blade, so I've had to apply glue before fitting it on the blade.

Love this product. Will fit a thinner blade but not a thicker one. Put it on my Gerber ripsnort and it fit beautifully. Made me like the knife twice as much.