Universal Hardware M8 x 20mm Black Nylon SPACERS Plastic Standoff Washers (Pack of 12)

I honestly haven't got a clue what these SPACERS / WASHERY THINGS are supposed to be used for, But, I have a drum, specifically a 16" floor tom made by Sonor if you're interested. I decided a while back to convert this drum into a bass drum for an "I-can-play-this-with-a-small-bass-drum-in-just-about-any-tight-corner-in-a-pub-once-this-pandemic-is-over" kit. Tension bolts, being highly engineered German lumps of metal wouldn't be the right size or length would they? No; the standard bolts that came with the floor tom are way too short, when I factor in a 3 cm deep maple hoop against a chrome 'triple-flanged' hoop {Triple-flange hoops allow drums to resonate more fully than other types, and they aren't very heavy. They improve rigidity, but mute the drum slightly because of the additional mass} ( I bet you didn't think you'd be reading the term "triple flanged" today, did you?!) anyway, the tension bolts I purchased were a touch too long, I'm a drummer not an engineer, so the selection of some kind of spacer was required - enter "Black Nylon SPACERS Plastic Standoff Washers (Pack of 12) (M6 / 6mm, 15mm)" - they have done the job perfectly and while tightening the 'reso' - resonant or front - head, ( you're not only acquiring knowledge about a silly word - "triple flanged!" but a knowledge of drum head replacement too ) the SPACERS have stood up to extreme tightening. They also look pretty cool against the bass drum hoop........ Anyway, if you've lasted this long reading to this point- congratulations - I gave up and left the room half an hour ago; stay safe during this pandemic, take care.

Brilliant set of various standoffs if you need to place them in bolts to take the play out

Not sure what these are meant for but screws were too long on a bedside cabinet so used these rather than sawing the screws down. Worked perfectly.

Nothing to dislike about them. I used them to hang down pipe brackets on an uneven stone wall perfect

Perfect for adjusting downpipe when it can't sit flush to wall. Easy with a small hacksaw to get the exact size if you need to adjust from what they are