BestEvMod for Ioniq5 LHD Screen Side Mesh Panel Black Wrap Compatible with Hyundai Ioniq 5 2022 2023 2024 2025 Screen Accessories

This looks so good in my car. I love how it covered up the grey on the dash.

I got this to go along with black screen protector. Once installed, it looks factory and blends perfectly.The install however, is tricky. It’s really important to align it right and use the included double sided tape to ensure a tight fit. Once the mesh is on the piece, take your time snapping it back in place. Pinching the edge can pull the mesh loose from the tape and cause it to be loose.Besides that, the only other gripe would be that adding another layer of material causes magnets not to stick as wellInstall aside, It looks amazing and really pulls together the black display. I definitely recommend it

As advertised.

Easy installation, but the cloth has some wrinkles — that hopefully will smooth out over time — and the cloth fits a bit baggy. Overall it looks better black and is a bit say change back to stock. I rate it 3.5 to 4.

Nice improvement and goes well with the black bevel screen protector, also from BestEVMods. Just be sure you orient it correctly on the plate and pull it very taught. Comes with double sided 3M strips to help anchor down.

Cheap material that has faded from the sun

If you added an aftermarket black bezel overlay to cover the stock white bezel on a Hyundai Ioniq5, this black mesh fabric is the missing piece that you need for a cohesive look.Installation was straightforward...which is good because there were zero instructions included. The hardest part was removing the plastic panel (with OEM white fabric) from the dash. Unfortunately, the plastic tool that was included with the kit is fairly useless. It is not strong enough to pry the panel and it bent almost immediately. Luckily, I had an extra spudger from a laptop repair kit and a thin metal shim that were able to safely pop the panel off the dash.The BestEvMod black mesh overlay was cut perfectly and can be stretched taught over the panel. Using a few pieces of the included double-sided adhesive strips kept everything in place. Once done and the panel popped back into place, everything looks completely stock and matches the new black bezel overlay perfectly!

The panel is an odd shape so fit was always going to be a challenge. I wrestled with this cover long enough to get it taut and flat before sticking it down and popping the panel back in. Except it got loose during that reinstall process…rinse and repeat two more times.I ended up calling it good with a single little wrinkle and the tiniest amount of slack. A gentle swipe toward the top makes them disappear for a moment, but I’ll probably end up popping the panel off eventually for another attempt. At least it’s easy with the included tool.Give this cover a try if you are going for the interior blackout look. Be prepared to compromise (or spend an hour on a 3 minute job) if you’re an absolute perfectionist.