Heavy Duty 5/8" Drill Chuck with K32 Chuck Key and MT2 Shank | #2 Morse Taper Arbor

Works great, would purchase again.

I replaced my old Jacob's chuck that came with the drill press in the 1970's because the grippers were worn out. This chuck is about half the size of the old chuck; but for a lesser chuck it has worked well for me.

This is a decent Chuck - but is 16 mm not 5/8”. What we needed so ok. It’s not as smooth as a Jacobs but will do the job well for the price we paid. It turned out to be same brand as the Chuck that came in our Chinese made drill press - which lasted 30 years of medium use. Recommended.

Using this on a Grizzly G0766 wood lathe. This is heavy duty and words well. Fits the tailstock perfect and also auto ejects when you crank the tailstock back. Holds drill bits solidly without any play. Very good chuck I would recommend.

Good

I needed to drill 9 holes 5/16 dia. through 3/4 inch of steel plate upside down on the ceiling, so decided to get this adapter to use my cobalt drill bits in my magnetic base Slugger (normally uses rotary broach type cutters with a 3/4" shank). What would have taken me hours and killed me with a hand drill only took about 30 minutes with this adapter in the Slugger working off a manlift. The price was very reasonable for the drill chuck with the adapter and key.

Fits perfect in an old Duracaft FM-1214, the taper on the arbor is an MT2. Fit and finish is great, time will tell whether it lasts. You do have to seat the arbor in the chuck as it comes in two pieces.

Runs true with no noticeable runout. This replaced the chuck in my Vevor mag drill that did not run true.