IGNPION G1/2" Full Brass Shower Head Flow Control and Shut OFF Valve for Shower Head, Hand Shower, or Bidet Sprayer etc

I had a leaking shower valve, I guess due to hard water in my area. Adding this product has stopped the leaking without too much inconvenience, and I did not need a plumber. I will get it sorted properly eventually, but for the moment, no leaking. One note, I think I installed it incorrectly at first. I put it at the end of the hose by the showerhead. This did not stop the leaking and made the showerhead heavy. Don't make the same mistake as me; install it at the valve side of the hose.

This product is heavy and is good quality. Had it for a few months now and still no issues. Its valve really does control the flow of water. It doesn't seem to slow down the flow at the wide open setting and then if you want you can use the valve to slow down the flow to any amount (even stop the flow). I would recommend to buy this to others.

- Bought to stop an old shower valve/mixer dripping - Screwed in hand right at the valve end of the shower hose without ptfe tape (didn't want to put the hose under pressure) and works a charm, pleasantly surprised - Only had a week so no comments on reliability

Works well on shower and nice smoothe operation. Corners are a bit sharp though so would be better rounded.

With this valve, I can now turn off the shower after soaking myself. I can then wash, and then turn the shower back on with the water temperature the same as when I turned it off. This shower is not thermostatically controlled as it is operated by the bath taps, so this valve makes it much more convenient to turn it off and on again. The valve looks good quality and I have not noticed any drop in pressure. It can also adjust the flow rate of the water. I fitted mine at the tap end of the shower hose as it was more convenient for me. It only took a few minutes to fit. If the lever does not not end up where you want it after tightening, you could try using extra/thinner washers in the fitting. Maybe also PTFE tape. Very pleased with this product.

I bought the valve to stop my power shower dripping after use. I had to buy additional shower hose washers as the boss on my wall outlet wasn't long enough to reach the washer in the new valve. This has the additional benefit of allowing a small amount of angular adjustment for the valve. Very satisfied with the end result.

My mains-pressure combi boiler mixer shower would always drip slightly unless you used excessive force to turn it off. There was a risk it would be pulled off its mountings! I can now turn it off gently and this little gadget prevents it dripping. Absolutely Fabulous! Update1... many weeks later and its is STILL WORKING PERFECTLY. Very pleased. Update2: After 2+ years (approx 2500 showers!) it has started to drip VERY slightly. I'm totally fine with that and have ordered another :-) Only downside is that the bore is VERY narrow so it does reduce pressure slightly. This is not a problem for us though as the mains pressure is obviously high and I have no other restrictions in the pipework..

Came with no washer so once tightened it leaked. Bought some washers hopefully it will stop leaks.

Habe in der Dusche einen Thermostat und der hat angefangen zu tropfen. Statt einen neuen Thermostat zu kaufen (ca. 150€) habe ich den Ventil gesetzt und der erfühlt meine Erwartungen. Jetzt tropft nicht und ich habe Ruhe. Klare Empfehlung.

No lo he utilizado todavía pero se ve muy bien y espero que me sea útil.

Very happy with purchase, arrived in perfect condition Thank you.