Spares2goComplete Motor Unit for Dyson DC04 DC07 DC14 DC27 DC33 Vacuum Cleaner (2200 YDK Type / 240V)

The cleaner seemed ready for the scrap heap until I saw I could still get a motor for it. Fitted it with a bit of advise from u tube and is going great. Dyson 33 is better than all the new Dysons Will be good for years now.

I bought this to replace my Dyson motor which had burnt out. Although the fitting of it was a bit complex this was only because of stripping down the Dyson to get access to the motor, having removed the old motor the replacement was easily installed with push connectors. I would highly recommend this motor

Good suction just as good as the original

Purchased this item as wanted to replace a DC33 motor that had finally given up the ghost after 8 years, item arrived on time and couldn’t wait to get the item replaced, I’d stripped the Dyson down in preparation so all I needed to do was put the new motor in and put it back together.The motor was relatively easy to fit although it was a little tight to get back in to it’s casing once the rubber boot had been fitted to it. The vacuum was put back together and I fired it up, it worked a treat, for all of 5 minutes! There quickly followed a smell of burning and a buzzing noise... I turned the hoover off and allowed it to cool outside. After a few hours, I gave it another try, still the same issue.I requested a return with the supplier as it was obviously faulty, I received a reply from them to say that I should clean or replace the filters and the return was closed, as simple as that! The vacuum was stripped right down, it was cleaned within an inch of its life whilst waiting for their new motor to arrive, including filters.To cut a long story short, after a few weeks I put the motor back in its casing and tried it without attaching any of the belts etc just to ensure that they aren’t the issue, I was met with billowing smoke from the vents on the casing, obviously faulty!Waste of money as far as I’m concerned and was met with an unhelpful response when asking for a return. I’ve now ordered a YDK motor and will write this money off as a learning experience. To top it off it’s cost a lot more than the price of the motor as my wife wasn’t prepared to wait for it to be resolved so I had to buy a new hoover! I am only repairing the Dyson just to prove a point to myself, I will end up using it in my office at work once repaired!

Works well enough, although not as well as the original (before it blew up of course...). I feel the suction is not as good as before, could be due to other factors, but I'm not sure...

Excellent product, works well and has restored our DC07 to its original powerful state. Not easy to fit, but plenty of helpful videos available on YouTube. Had to also replace the pre motor filter housing (yellow plastic round container holding the sponge filter). This had become blocked and caused the new motor to overheat and cut-out. Good value for money. The Dyson DC07 is now fairly old but well worth keeping going as it is very efficient.

Lots of screws to remove, fitted the motor only to find the clutch was the problem.

Bit fiddly to fit, takes an hour or so! Involves a full vacuum cleaner strip down! If you’re not good at jigsaw puzzles you need someone to do it. But, as opposed to the cheap Chinese copy for a £10’er I tried, which burned out almost immediately, this is a decent one. Not so sure about the suction as wanted the original powerful 2,200 watts of suction but I don’t think this quite gets there (I’d guess about 1,600 watts of suction power). But all said & done I’m pleased with it.(Q) Would I recommend?(A) yes!I’d give it 85% on suction but my old faithful DC07 lives again!