Set of Four Splash Shields with Clips for 4Runner 2010-2024 (Fender Liner, Apron, Shield, Splash Guard, Skirt, Guard, Seal, Splash Seal) A

Worked exactly as described, clips could hold a little better but does work nonetheless.

Install was pretty easy, hardest part was removing the clips. The rear pieces were slightly bigger than the original, Can't compare size for the front because they were completely missing. I'm glad I found these instead of paying 150 bucks at the Toyota Dealership. I think these should last longer because of the thicker material.

I installed these on my 2003 4runner. The one on drivers side ripped shortly after installing at one of the mounting holes. I was able to punch a small hole and secure it with a zip tie but that also ripped so it was just flapping about. Kinda lame. They seem like they are nice and I like that they included the hardware but I can't say they are amazing since they didn't even last 6 months.

I installed these on my 2004 Lexus GX470 because the splash liners were damaged and partly missing when I bought it. The material is thicker and more pliable than the stock material (in a good way). The clips provided didn't have a deep enough bite to fully seat into the frame holes of my 2004 GX470 (I CAN PULL THEM OUT WITHOUT TOOLS BUT THEY STAY IN DURING NORMAL DRIVING SO FAR 500 MILES), YOTALINERS maybe try some different clips to find a more secure attachment. The fit is perfect on the forward pieces. The alternator (passenger side) is covered nicely and drivers side fits perfectly as well. The rear pieces fit with a big wrinkle toward the rear tip so I pulled it tight and made new holes for the rear-most two mounting points with an awl on my leatherman (easy fix). They fit like a glove with minimal work (took my 30 minutes to remove old clips + install new liners/clips and I've never done it before), I used only a leatherman tool to install them and YOTALINERS saved me considerably over buying OEM from Lexus. Also worth mentioning, my GX has the Old Man Emu 2" lift installed and fitment of this product is not affected whatsoever by the lift kit. They fit the same lifted or not as long as you have stock control arms.

I read the reviews that say... like a glove, and exact fit. NOT even close. They are much bigger. I should have taken a picture but the bottom holes on the back ones are probably an inch off. The fronts ones fit like an XL shirt on a toddler. The question is - where do you want the excess? I would not buy again.

Indistinguishable from OEM other than being a little thicker and heavier duty.

Bought these to replace the shredded stock splash shields on my 2016 4Runner. First off, I want to thank the manufacturer for including more replacement clips than you need for the install since immediately screwed up 2 as soon as I took them out of the bag.Buy these, you will not regret it. Should last a lot longer than the crappy stock ones.

Fit without any issues and felt like thicker rubber compared to aging paper like rubber material that's crumble in your hand.