Pipe Tubing Beader Roller, Manual Tubing Bead tool-Well Made Tubing Beader Tool Roller, Intercooler Tubes to Fit 5/8" and Larger Tubes（BLUE Upgrade）

This little rolling tool does a great job of bead rolling on tubing. It can also be used on flat material to make a stiffening bead along the edge of a panel. Made of precise quality material.

I don't see this tool being for everyone but if you have some metal pipe work that ends will need flared this is the tool. It is kinda genius in how you hold it, you don't, you just mount it in a vice and let the flaring begin. super easy to use once you get the hang of it. instructions are there and legible.

There aren't many times I bead a tube, since have a lot of threaded barbs, I normally just thread and use a hose clamp over a barb. That isn't always possible, so for low pressure applications like fuels or oxygen behind a regulator in a series of solenoid controlled lines, I think this is awesome. The point of beading a tube is to provide an area for the hose and clamp to butt up against so the hose doesn't blow off the tube. It's only good in low pressure applications. This beader works great! I actually expected it to be pretty low quality, but I have been reassessing how I attach hoses going forward.

This is a very solid piece of tool here. It easily goes right through any material i feed it. Solid built and easy to set up and use. I expect no problems from this for years to come.