High Density Polyethylene Sheets HDPE Plastic Sheet Board for DIY, Heavy Duty Industry, 1/2" Thick,Size 6" x 12", White Color

Wanted to cut some extensions for base plates on mags that are flush fit (Sig P365 X 12 rounders) so the mag protrudes from the magwell. This stuff worked great. Cut it, drilled it, scuffed it up, cleaned both surfaces, high strength epoxy and BOOM, mags insert and engage the mag release much easier now without being so thick that I have to worry about over insertion.

I used this to make a replacement depth stop clamp for my 1980s craftsman drill press. The part is no longer available, so it used the original to trace the outline, cut it out and made a new one. It's been working fine for months. This material is a easy to work with and stronger than the original, brittle plastic part.

I used this to take up the play in a Harbor Freight 20 Ton Press I just purchased. It fit in the movable arbor arm to side rails to fill the gap & Is very slick.

Worked as designed. Recommend purchase for the money

Would be five stars if it was flat. Came warped but still worked for my use

Good quality, nice to work with. The pieces did have some scratches but nothing you can catch with a nail. Cut them with a jigsaw just fine, and the color is accurate

2 sheets Came warped.. Measurements are slightly off... I ordered gloss black and it literallly leave scratches wiping it with a microfiber towel. Complete JUNK! do not buy the gloss black.

Image on listing shows three pieces, but only one was received. Not a good value for just one sheet. Surface is smooth, with just a few imperfections but corners had some minor damage. The sheet is solid and strong. I'm using it as a base for a heavy object on the floor, not where anyone is inspecting it closely.