PK-10 Plasma Cutting Electrode 770791 Nozzle Tip 770795 for Hobart Airforce 12ci Torch Plasma Cutting Torch Consumables 770791 Electrode 770795 Tip

Ordered these a little apprehensively as they were less expensive than the ones I normally order. Changed them out for the first time last week and they are doing just as well as the more expensive ones. I will order these again when the time comes.

NOT SAME AS TIP FOR HOBART 12CI. The one on the right came with Hobart 12ci machine, one on the left is this product. At 12 amps the distance this creates from work piece with the guide is too far and creates a sloppy cut. Do not purchase this product if you use the standoff guide supplied by Hobart, which is a must with this machine. I tried to be cheap and go with these, but don't waste your time and get the actual product from Hobart.

These fit my Hobart Plasma cutter but they are shorter than the original ones. I can use them but not with the stand off guage. I will not buy again.

If I could give this product zero stars I would. These are garbage, get about 5 minutes on the Hobart Air Force 40i before needing to change. Do not buy

Everything looked good

Wasnt for me, but husband likes it.

Noce job

Did it job