Longruner 7 inch Raspberry Pi Touch Screen Case Holder for Raspberry Pi 3 2 Model B and RPi 1 B+ A BB Black PC Various Systems LSC7B-1

This fits the Longruner 7" screen perfectly. Assembly is a bit of a puzzle, but you just need to stop and think and plan a bit. It also looks like a few reviewers were mystified by having to peel the protective layer off of the acrylic. The acrylic is a glossy black with no markings whatsoever. I'm not using the supplied feet, but I did try them out and they were stable. It looks like you have a couple of mounting options for the feet. The pieces were cut out nice and no jagged edges or gauging.Not bad at all for $11

It is a great case for the longruner 7' touch screen. It's a pain to build without proper instructions however I did manage to get it together with the lack of directions. Note that this case is for the longruner 7' screen only.

There are no direction whatsoever. That being said, there are picture on here that you can figure it out. It's not that hard. It didn't fit my screen but it was easy to cut for an exact fit. The screws are microscopic, so be careful, don't lose them.

product does not fit the screen it is advertised for. Further, it is simply a set of 4 C&C'd boards made out of cheap flimsy plastic with the adhesive wrapper still applied to it, rendering it totally useless because it cannot be removed without damaging the product. Defective on arrival, don't waste your money.

The pieces of black acrylic were nicely finished with only some minor plugging in some of the screw holes. The big minus is the complete lack of instructions. There are an incomplete set of instructions in the form of a few photos within the product description. I guess the idea was to avoid the expense of translating a set of instructions to English. I would rather pay more and get a good set of instructions. Since I'm 70, I don't have the hand-eye coordination I had fifty years ago. The nuts and bolts are very tiny. I lost track of the number of times I dropped a nut about the size of a grain of rice. Down on my hands and knees with a flashlight over and over. :-( I purchased a Waveshare 7 inch touch screen from Amazon. I had to use my Dremel with a cutting disk to make modifications on two pieces of black acrylic so the touch screen would fit. Be sure and use the provided clear plastic spacers on the two long screws on the right side so the back is not bowed as much. I agree with other reviewers that the case does not provide complete protection. Also, care should be used when installing or removing cables to avoid breaking off the connectors.

Looks well made but does not work with either touch screen i ordered. Need the very basic display for this to work with.

Good product and fits my 7” monitor.

It is what it is. Be sure to remove the protective film. Extremely easy to assemble if you aren’t an absolute moron. Only wish they would’ve added mounting holes to give the option for vertical leg mounting.