Hotop 20 Pack Shower Hose Washers Rubber Washers Seals for 1/2 Inch Shower Head and Hose

I needed to replace the washer in the standard tubing of my detachable shower head. This fit perfectly and was easy to place in my shower head

I have a Moen handheld shower (on adjustable arm) that needed new washers on both ends of the metal hose. I could not find the right size at the big stores. These fit perfectly. They are the requisite 3/4" OD size and made a good seal. They are slightly thicker than the original washer, which is a good thing as the thread on the Moen bottom out quickly. These washers provided a snug fit and fixed my leaks.

great

They do what they're supposed to and don't leak.

I bought these washers to replace those in an old shower set that was leaking. When I removed the old washers I realized they were of a more flexible type from what I purchased. As a result, the washer did not compress enough to stop leaking. My wife convinced me to purchase a new shower set which is working out fine. That’s the way it goes sometimes!

I asked in several hardware stores and to my amazement, none of them stock this size washer even though it fits nearly every shower head I've ever seen. I ordered them to replace a shower head gasket in my RV and it was just right for the inside shower and also the outside shower. While I was at one plumbing store, I told the salesman who seemed as if he'd never heard of this size, that I would order some and bring him a few to have in stock. Maybe I'll do that the next time I'm by there.

For reasons I have yet to figure out, most showerheads and faucet aerators don't come with enough or the proper type of washer to be able to be tightened without leaking or ending up cracking the threads on the showerhead due to overtightening. Where I live, the water is quite hard which takes its toll on plumbing fixtures. It is good to have a supply of these rubber washers on hand to be able to do the job right the first time. You just use as many or as few as the situation requires. P.S. Don't forget the Teflon thread tape!

I wasn’t aware at first that they were correct gaskets until I saw knockout for center hole, perfect size