NeutrikNDM DUMMY PLUG FOR MALE XLR CHASSIS CON. (10 pieces)

These plugs are a soft rubber material that slides easily but firmly onto a Male XLR jack. We use them at beach venues to cover unused jacks to keep sand out.I only wish you could get a 5 Male + 5 Female combo pack.I purchased from Metal Magery/Fulfilled by Amazon in 2024 and they appear to be Authentic Neutrik and seem well made.

This is almost a perfect solution for protecting your charge-port for the OneWheel+/+XR. It does't form a perfect seal for the entire cavity but it does fit well within the charge-port. This will prevent most of anything that could find its way in there, be it debris or water. However there's nothing that these can do about the surrounding area of the cavity. This means that it should be fine for any debris you run across, but you might want to be more wary for things like wet or snowy conditions. Sometimes condensation build-up can cause problems that wouldn't occur when unplugged if moisture collects around a seal that normally would evaporate or be trivial before reaching the inner-side of the seal(s). It probably won't be a problem, but the plug is not a tight fit, just an adequate one.

They fit very snug and keep debris and small amounts of fluid out. I use for my onewheel charging port to prevent debris, as it uses a XLR charging cable. Doesn't fall out or get loose after taking it out and putting it back. Highly recommended

Works for OneWheel XR but because plug sticks out so far, they will be knocked out during transport/riding. PRO TIP: Snip off top half of stub/handle with a scissors & stuff ii into the end of the rubber cover as pictured. Will still be water resistant, but it will no longer ever fall out.👍

These dummy plugs work perfectly for the XLR power port on my OneWheel XR. Still on my first one after over 300 miles which includes a lot of rough trail riding. These plug covers fit very secure and I suspect the only time I'll lose one is if I just simply remove it myself and misplace it.

The media could not be loaded. Does not fit! These are too small for XLR anything. I couldn’t even get them to fit Male or Female by stretching them out.

They fit as described to xlr plugs used on my open channels for db25 and also mic cables not hooked with mics. It’s great to find here on Amazon and am surprised they’re not sold in the mega online music stores. Thanks

This is exactly the same plug I got when I ordered stuff from a excellent online retailer that sells Onewheel accessories. The plug might fall out and you don't notice till you are miles away. It happened to me, and now I have a bunch of spares that cost less than a buck apiece.