JB Custom Fabrication *Made in USA* D300J Stainless Steel Twin-Stick Shifter for Jeep D300 Transfer Case (The Original Stainless Twin-Stick) Beware of Inferior Off-Shore Copies.

Looks great in my Jeep CJ 7 Laredo. I love the fact the I now have 2L. Pretty easy to install. I did an overhaul on my transfer case so not real sure how long it would have taken to just do the install of the shifters. Well worth the money the quality of the product is outstanding. The only thing is the shift knobs blank but they do offer upgrades stainless knobs and for the price I am not complaining. I would without a doubt buy again if I buy another Jeep

Great design. Quality materials and the included boot looks good. I have a Dana 300 attached to a GM auto trans. The tunnel and floorboard had to be cut slightly to accommodate the new clocking of the t case but all is well, the shifters work great.I advise anyone installing this to do it while the case is out of the Jeep. You should open it and remove the the little pills inside so you can run the full range of gears as well.

They're not horrible to install but it's not a cake walk either. It's just the nature of the location, access is limited. I had to use the torch to heat and tweek the angles.. Don't heat the sticks, they'll crack, stick to the brackets while in a vice. They are heavy duty!

This is a great kit. Save yourself the time and money and don’t buy the Omix erector set joke of a kit. This is all stainless and well made here in the US. Can’t beat the price and quality.

Install was very straightforward, I did have to loosen the crossmember on one side to drop the transfer case down about 1” so the large bolt would clear. Also there wasn’t enough of a gap for the last washer and I had to go with just the nut. Plan to heat the shifters up and bend them slightly, currently they do contact the tunnel cover while driving.

We did have to modify the shifter shafts, they were bent slightly off, heat to cherry red then bend as needed. Strong materials & function well.

I have seen this shifter set from JB Fab for a couple years now and finally purchased one for my 1984 CJ7 project. I had to do a small amount of bending to each shifter to work with my clocked Dana 300 T case, but they work marvelously! The hardware and boot are included and very good! I highly recommend this shifter and I am looking forward to a set of engraved billet knows to go with it. Worth the money!

Awesome product