Prime-Line M 6258 Frameless Shower Door Bottom Seal for 3/8 In. Thick Glass Doors – Stop Shower Leaks and Create a Water Barrier, 36 In., Clear Vinyl (Single Pack)

Just installed. Used the old one to cut the new one to length. Make sure the angled part that sheds water is facing into the shower. Cut the end closest to the hinge and file smooth. Fits very tightly. Used silicone spray to grease it up to get it on. Used a small hammer on the end to tap it onto the glass. Fits perfectly. Should last several years.

These seals fit perfectly on my 1/2" glass shower door and were super easy to slide on. The only downside is that they don’t come pre-cut to the length of the door. I had to trim mine down, which wasn’t the easiest—ended up using a hacksaw to get a clean cut. Still, great quality and does the job well once installed.

I think it would be better to make one from rubber of a slightly soft quality. But overall it is worth the money

Just what I needed. I had to cut it to shorten it but it fit perfectly. I couldn’t find this size at the big box stores . This one was very reasonably priced.

Fits snug and does the job as long as you measure well and your shower door is level with the floor.This is the second one I've bought and it's not because the first one failed but because my shower door is not perfectly level with the floor and I have to trim the sweeps. I happened to trim a little too much on the first one and the sweep was no longer touching the tile. It still worked fine but not as well as it should and if I don't do something right I'm going to do it again.I'm not sure why one of the pictures of the product shows the sweeps off the tile. If they aren't gently touching and your tiles aren't angled into the shower it will pool up and run outside the door. Putting it on my doors as it came from the package caused it to jam and I had to pull hard to open the door. Once again that's not the products fault.With the new one I measured the distance on both ends of my door and cut the sweeps to match the distance from glass to tile. It's not easy but you need to learn to be handy to problem solve and overcome the annoying things in life.For the people that are getting leaks I'm betting that it's because of one of the following scenarios:1. The gap under the door is larger than the sweeps.2. Water is going through the vertical gap between the door and the other glass panels adjacent.3. Their tiles were installed poorly and water is running out of the shower.4. They shower like a baby bird in a bird bath and get water all over the door.It's not going to be a 100% water tight seal but that's not what it's supposed to be. It does what it's supposed to do which is keep splashing water from easily seeping and pooling on the outside of the shower door. If you shower like a normal human and your shower head isn't aimed directly at the door you should be good to go and happy with the purchase.

Worked great! Had to cut it down to size but turned out great.

Works on our shower door. It was hard to cut and left a rough edge. It's also hard to spread open and slide open. Eventually got it on and the stiffness works for it still being on our shower door

Fast shipment, nice fit, easy to install. Would recommend.