Greartisan DC 24V 20RPM Gear Motor High Torque Electric Micro Speed Reduction Geared Motor Eccentric Output Shaft 37mm Diameter Gearbox

Works just fine. I needed a DC motor for my DIY project and I see no issue's with this motor. up to 15 kg torque.

The media could not be loaded. I used this motor for my work pumpkin contest and it worked perfectly! It was easy to use and quiet, and ran consistently when turned on.

Very good quality no issues at all

This low speed motor (60rpm) has more gearbox noise than I was expecting, which is still tolerable though a bit annoying. Because the motor is geared down to such a low speed, the torque is enormous making it almost un-stoppable. But the gearbox losses make the no-load current pretty high. I have had it running under light load for about 4 hours now - It does get slightly warm, the current and speed have not varied, so it seems like good value.

it met my expectations for my experimentation

I built a filament respooler that called for a 100RPM motor. (not pastamatic, the original one) I bought the recommended motor but it was loud and to be honest, a bit slow for my tastes. I found this motor which is faster and quite a bit quieter. (by no means quieter, just a lot quieter than the other motor I used) I am guessing the noise is from the gear box. I can use full speed on my motor controller but it is a bit too fast. I can slow it way down and it still works. At a certain point, slow is just off. (pretty close to the off position) I recommend this over the motor listed on printables because it is quieter, faster and much less expensive.

The size of the motor was perfect to create a rotation device for a roaster. Low noise, just the right amount of power as I wanted to spin slow. It worked as intended.

This motor and gearbox work just fine, however you should be aware that the motor itself is quite loud. I’m replacing an old worn out motor/gearbox with the same specs, and this new one is twice as loud as the old one.