AC InfinityAIRPLATE T8 White, Quiet Cooling Dual-Fan System 6" with Thermostat Control, for Home Theater AV Cabinets

I am very impressed with the design and quality of this fan kit. The included installation templates are excellent: sturdy, accurate and easy to use. All of the components are solid and attractive. I am very happy with this purchase.

Installed this in my battery box in my camper van as it was getting excessively hot. Seems like it moves enough air.

Replaced an entertainment center and found that the new one had nowhere near the airflow and clearance that the old one had, causing a couple electronics to overheat. I found this set and it has been an amazing find that exceeded expectations. First, the quality of these fans and the controller are fantastic. The build quality is perfect, no cheap fittings or material to be found. Installation is a breeze if you just follow the instructions and the provided template. The fans fit like a glove. Setup is simple, plug in the fans to the controller and a few simple preference settings and you are done.The cabinet stays ventilated and cool, one fan flowing intake at the bottom and one exhaust at the top. Where I was seeing overheating warnings above 100-110 Fahrenheit and beyond, this setup has kept the temperature well below 100F with a PS5 running and audio equipment. Well worth the purchase and peace of mind.

Good system. I used this to turn an Ikea BESTA with a metal mesh door into a computer cabinet, and I was able to fit both fans onto the flimsy backboard. I attached the controller to the front of a shelf with command hook/loop fasteners. The fans run quietly and efficiently. The "smart" mode is the best. Nothing has burned out... yet!

These appear to be high quality, are not too hard to figure out, are reasonably quiet, and look nice when installed. I have mine running for about a week now.The only difficulty I had was cutting clean square holes for mounting. The included templates were very helpful, but I had no clue what the best tools were for the job. That's on me, though, but you might watch a YouTube or something if you are not a carpenter.Noise wise, it is pretty good, but a little loud at max speed, if it needs to run that fast which it likely will not if properly sized for your needs.

Very impressed with the build quality of each component. Came with both wood screws and fairly long machine screws with appropriate nuts (wish it came with washers as well) for mounting options.Cutting the hole is fairly straight forward with a jigsaw or router (I used a router, would have been faster with a jigsaw, but I used what I had on hand). The components all have a fairly wide mounting border to hide poor cuts from the front. Looks professional when installed.No needing to worry about hacking together some sort of raspberry pi/Arduino with temperature sensors etc. Everything is already thought out after you have mounted the components (using one as intake, and one as exhaust). 1X USB port for each fan, 1X DC power adapter for the controller/fans, and 1X port for a thermocouple (which comes with a zip tie and sticky zip-tie anchor for mounting.Only reason I'm giving this 4 stars instead of 5 is as mentioned in another review, the controller is pretty dumb even in "smart" mode, and ultimately ends up just getting to your setting temp and then turning on and off every 30 seconds as it oscillates to the setting temp and one degree below. The "smart" mode simply sets the fan level proportional to how far over/under your setting temp you are, but still ultimately runs into the same problem of oscillating between one bar and none every 30 seconds to a minute or so.I'm building a computer desk, and used the IKEA Alex Storage unit as a place to hide my computer tower. This system has the capability of keeping the cabinet pegged right at 75°F with only one bar of power, which has a noticeable hum of the fans with no other noise in the room, but actually is less noisy than the tower outside of the unit is with it's multiple fans.I ended up just setting it to the "on" option, with 1 bar, instead of having it oscillate on/off every 30 seconds, with hopes that eventually I just grow immune to the small amount of noise.Haven't put my computer under any substantial load yet, but if I do, I imagine it will have no problems cooling as I still have 5 more bars of power available (or if I'm doing something really intensive for a while and it still can't keep up, I can just open the front door of the storage unit an drop the temp almost instantly).Overall, this is a good buy if you are going to be putting expensive/heat generating equipment in an enclosed location, and want a professional looking, and headache free cooling solution.

Excellent cooling and lots of configuration options. Definitely the solution I needed for my structured media cabinet.

Using this cool down my new entertainment center housing my PS4 and Xbox. Without it, the consoles overheated and shut down within five minutes of being on. With these fans and unit installed it never goes over my set temperature. I can't hear the fans running either.Install process was easy but a hassle. I had to drill holes then saw around, but it was convenient that they included a stencil thingy to place against the wood and trace out. I wish I'd done it outside though because man, the dust. But nothing a vacuum and lots of dusting couldn't fix.The "auto" setting is what I use because its super easy to set up. There's the option for variable speeds and a window for temperatures. I'm in too much of a hurry to figure all that out so I'm glad there's just a simple "auto" setting for me to use. I set the temp, when it reaches that, the fans turn off. When it drops below, they shut off. I'll set up the variable speed temp thingy later.Overall, I'm extremely pleased. The unit works perfect, the install was painless, and the quality is good.