HogueHandAll Beavertail Grip Sleeve for Glock 17, 18, 19X, 20, 21, 22, 24, 31, 34, 35, 40, 41, 45, 47 (Gen 1, 2 & 5)

High quality, and exactly what you would expect from Hogue. The rubber is firm and strong. adds a good bit of thickness. make sure to follow their instructions. i ran mine under hot water for about 5 min. and it went on without issue.

So for the price this is an amazing item. I am 6'3" and have corresponding sized hands. My 9mm Glock 45 fits my hands well, but I still wanted a little more grip. This was the perfect solution. Grip feels much more solid and controlled.Installation is not easy at all. But if you work smarter you won't need to work harder. I used the boiling water and windex route. First, pour boiling water into a bowl and let the grip soak in it for 30+ seconds. While it is soaking spray the grip with Windex and don't be stingy, it should be dripping off. I installed it with the slide removed. Using tongs pull the grip out of the water, shake loose any residual moisture, and install as quickly as possible. I did not need to use the two plastic strips that they suggest, but it did take a few attempts to get the first part of the Hogue grip over the Glock grip. Once the first part is attached quickly slide it up using any means you can. The windex gets super slippery so I kept a towel nearby to dry off my hands during the process. I also re-dipped the Hogue into the hot water during the process. The trick is to be prepared and to move quickly but efficiently. Heat and windex are your friends in this. Be patient and deliberate and the install won't be easy, but will be possible.

NICE grip!Tough to put on but worth it.Adds a little girth to your grip and finger grooves too.

Install was a bear, tried boil (made it to slippery), used heat gun (to hot to effectively touch), used spray WD40 once started onto base, worked and evaporates with in few days! Love the feel and fit on my hands!!

Really helps grippage on gen 2 glocks. Follow instructions, especially making plastic install shims. After boiling Hogue, & windexing sidearm reciever grip is on in 5 mins

It was a great grip, fits in the hand well, and very high quality. But, it was damn near impossible to get on. I followed the instructions by putting the grip in hot water, using plastic cutouts from the packaging, and using windex. Despite these steps, it took about an hour to put on. In the end, it was a great product, but I wish the manufacturer would make it easier to slip on and/or off.

False information!! These grips absolutely will not fit a Glock 20. No way possible!!! Please be careful and buy it only for the G17 and other smaller frame Glocks.

I was hesitant at first before ordering mines but i highly recommend this grip, it completely transformed my G19x. The ergos feel so good in my hands it’s insane!