Lift Chair Remote Replacement, 5 Pin 2 Button 90 Degree Power Recliner Remote Replacement Parts for Okin Limoss Lazboy Pride Catnapper Golden

Works great on my chair. I ordered one as a back up (I have 2 chairs). The original and replacement remotes have a stress relief on them that will wear/break if they aren't taken care of. Once the stress relief breaks, this allows the cable to eventually pull out of the remote or the remote quits working. The originals, after a couple of years of tugging/usage; the stress relief broke, they start showing signs of erratic button operation, one remote was actually warm to the touch. Time will tell if the replacements have similar issues.

Works just as expected and provided a very cost effective repair.

Quick delivery, Great price.

We are very excited that this replaced our broken remote and easy to install !

It worked on my lift recliner

My sister-in-law is recovering from shoulder surgery in a Macy's recliner with built-in buttons on the side she can't reach. She needed assistance 24/7 to get out of her recliner.I traced the button wiring to a male plug with a pinout that looks like this plug. That's a match: A 5 pin DIN plug has been a standard for decades, used for vintage keyboards and even now for MIDI electronics.I swapped in this remote for the existing button wiring. One could buy a generic 5 pin DIN Y-splitter with straight through wiring (check!) but we didn't. Don't be fooled by overpriced splitters targeting the recliner market, to deliver in weeks.We were careful to route the cable through the chair so that the remote couldn't fall to the floor, out of reach.Installation was not a breeze. I needed to cut plastic flanges from the female port, and trim 1/4" of plastic from the male plug barrel, to get a secure connection. Careful use of a steak knife worked better than any tool one might find in a shop.We carefully watched the chair go full cycle many times, and secured the cable with cable ties so there was strain relief with enough slack to not pull out the plug in use, and so the cable wouldn't get scissor-sliced by the chair. This is "common sense" learned through hard knocks, but a beginner could easily figure out these same challenges with patience.

Was easy to install and was compatible with my lift chair that was purchased from Mor furniture in Sparks, NV.

We have faux leather recliners with Kaidi motors that we bought back in 2018. One of the arm controller units partially went out over Christmas and are no longer available. Nobody has parts for these units anymore as the company is out of business. I called and searched around for weeks trying to find replacement parts.This VERY inexpensive unit has solved my problems.It's very affordable and works with Kaidi motors. My only draw back to it is that it doesn't fully operate all functions of the chair, but I knew that when I bought it. This is just a two button (up / down) controller. I will look to buy the more expensive model now that I know it truly works with our chair motors and keep this one as a spare.