Fernco Pow-R Wrap Plumbing Pipe Leak Repair 4-in. x 252-in.

The media could not be loaded. Amazing, I had some horribly busted and rotted out sewage pipe under my house. This did the trick. Just follow instructions. I bought extra JB Weld to cover holes and separation in pipe before wrapping just like on instructions. Seriously this fixed a major problem and will last a long time before I need to replace.

I had a somewhat similar repair, or more like an improvement to make, on a sewer line that exits the foundation on an older home. Here a 4" metal pipe was incorrectly mated to a PVC pipe using nothing but a short PVC plastic coupling and the top of this coupling was cracked (but in all it wasn't leaking yet). I didn't want to disturb the line with fear of something else going wrong as it usually happens when jumping into tasks like these and in short, I found this product and it worked well.I completely wrapped the joint with this fiberglass wrap with a fairly wide overlap on each side. It dried hard after about an hour and it avoided a potential time consuming repair. From the looks of it afterwards, I consider it a nice permanent fix until I suppose that metal 4" drain eventually corrodes which at that time the whole line can be replaced during a remodel or such.As I found on a similar review, my advice is to throw away the provided gloves in the package and get a pair of rubber dish gloves instead as it's a sticky-sticky mess and durable gloves are needed. The directions are pretty clear, but be sure to add water in the packet and work/squeeze the tape well (in the package) before using, and lastly, keep the wrap tight and pull it snug during the installation. Hope this helps.

No putty in the package

Clean the pipe up well and it goes on nice. Instructions are good and are easy to understand. I patched a 4" drain line with a hole in it over 1" and it worked well. I made a worm out of the putty and stuck it to a piece of tin and around the hole.Took about an hour total,crawling under the house a few times ,cleaning the pipe and applying the tape. I rerolled it while in a pan of water to make sure all of it got wet. It worked well and I'm sure it will last a long time.

it was hard to work with and end result was not pretty but worked

I had a minor leak in a drain line and by using this as advertised it sealed it. A plumber would have cost several hundred dollars.

I was able to use this to stop a small leak coming from a lead bend pipe in my bathroom ceiling. Because of the location it would have been costly to replace. This product stopped the leak. Great product

Covered a dollar size hole in 3 inch cast iron pipe, holds for now until a full replacement can be scheduled. Per the instructions there should be a putty and a gloves included, neither was in the package. Was mainly looking to patch an edge but ended overlapping more around the joint. It was enough to cover a palm size hole. What made it difficult is that the section with a hole was a Y with a clean out. If you have just a straight pipe it’ll be so much easier to wrap. Solidified in about 45 min. After 30 min it was so sticky it ripped latex gloves.