GM Parts 291-315 Rear Axle Shaft Seal

Fit was perfect, no leaks.Even came pre loaded with grease where the axle slides in!I installed these on my 2013 Silverado with a 10 bolt rear end.Be sure the surface is clean and no burrs are left behind from removing the old seals before you start putting these in. They’re quality seals, preparation is key for the life of these.I got 140k brutal miles out of my OEM seals with tons of towing, hauling, blazing hot 100+ degree Florida summers, and maybe some racing 🤙 even then it was just a few drips here and there.These seals are so inexpensive and not hard to replace, just stick to OE and buy these if you need them.

Genuine GM part, fit perfect and no more diff fluid covering the rear brakes of my 2000 Silverado. Note that if this seal leaks you likely have a venting problem and should address

This fit my 1993 Chevrolet K1500 Silverado z71 with a 5.7 liter engine and automatic 4l60e. Worked just fine.

Good replacement

work good

Item didnt fit my 2000 silverado 1500 2wd 5.3 (but Amazon said it would fit, it is hard to get all of these parts 100% accurate) but it looks to be great quality. It was too small for my yoke. I went on gm parts finder and found this is another seal that should work and Amazon says this one also fits so we shall see. Here is the other part on amazon if you run into the same issue. Make sure the little tiny spring stays in the seal, mine fell out of the original old seal on my truck.I may add a photo later...ACDelco 26064028 GM Original Equipment Differential Drive Pinion Gear Seal

Still sitting on shelf, have not needed it as I thought. Turns out the bearing and seal was fine. So I get to check the gear lash some time soon.

perfect fit