ACDelco 24202835 GM Original Equipment Automatic Transmission Front Wheel Drive Shaft Seal

These fit with no issues.I put about 7500 miles on them so far and they are holding up. I’m pleased with this purchase.

Fit exactly how it should.

Worked fine.

The axle seals wear over time, and so if you're replacing the CV axle you need to replace the axle seal. Note that the GM 4T65E transmission has two different size axle seals for the left (ACDelco 24243353) and right (ACDelco 24202835) axles. So make sure you pick up both ... Amazon usually recommends the other one in the "buy these together" field.In order to remove the seal, I recommend using a seal puller. They are very inexpensive, and unlike screwdrivers and picks they don't run the risk of damaging the housing the seal sits in.In order to seat the seal properly, you will need to use one of the following (a) a really big socket (35+ mm) (b) a similar big diameter pipe (c) a race and seal bearing kitI recommend (c) simply because there are plenty of other oddly sized seals in GM vehicles that a set like that will go very far. I am very certain that the people complaining of leaks didn't seat the seal properly, or worse they mangled the aluminum housing!

GM makes FM sell these seals to them at cost $1.95 each. So there is a real mark up on these. I worked for Federal mogul 2 yrs. in QA, where they make these seals or ones just like them.The really good seals have an internal ring spring to hold tension on the wiping surface. Seems well made, not used yet. I can't find the part # for the left side to match this seal. I wanted to change them both at the same time.