DS18 DB1034 Distribution Block 1X0-GA in 3X4-GA Out for Car Amplifiers

Designed well, compact, sturdy, holds tight.

Product fits my build and budget

Good quality

The ports on this distribution block are true to size which is a relief because that gets lost in translation often. The block is actually covered with a clear plastic top that snaps in place with 4 tabs. The tabs aren't the easiest to work with and I actually had to use a thin screwdriver to pop it off while being careful not to break them. The clear plastic base is screwed to the distribution block and has 4 holes to screw it down. The screws to tighten down the cables have a beveled end with slight serrations on the edges which could be a good or bad thing. Those serrations are going to chew into your cable and actually give you a better connection especially if you have something like a 10,000 strand monster cable. The downside is that once you disconnect that cable, some of the strands will fall off and you'll need to chop a half inch off the cable to get 100% of the conductors back. If you're using a 110 strand 2 gauge starter cable like me, each strand is thicker and unlikely to be broken by those serrations. Starter cable is still acceptable to use for car audio because although it's not as flexible, it has enough flex to resist road vibrations when used in short spans. Overall this piece was a good fit, did it's job and looks nice.

Pretty good for the first person starting out wanted to try something cheap for now then will show up grades later

Nice item but unfortunately I went another route so I didn't need it. It cost almost as much as the item to return it. I kept them , hopefully I can use for future audio builds

I installed 2 of these in my car which has all 1/0 guage running thru-out entire vehicle. I have 3 Orion amps that require big power. I was able to split my power coming from my battery into 3. (1) 1/0 in, (1) 1/0 to my amp and (1) 1/0 to the rear for my other 2 amps plus my capacitor. And same scenario in the back of the car. I had NO problems at all getting my stripped wire into the fittings. Usually company's say 1/0 but it wont fit. These, no problem at all. And I've read some people complaining about the covers. If you know how to put them on correctly then you wont have any problems at all. Both my covers went on very easily and are on very well. Put one side in first then squeeze a little and the other side snaps right in. I love em. IMO

I hate the looks of wires going everywhere. With this power block, there's only 1 wire from the battery. I can hide the branch circuts unlder a sear. Much nicer look .

excelente calibre 0/1 sin problemas , buena calidad es duro y el precio muy accesible para hacer puentes tengo otro marca stinger pero este se siente con mas calidad , recomendado para tu sonido

I used this distribution block on my trunk setup in my car. I had a 0ga wire from the battery to the truck, where the distribution block split to 2x4ga wires. one for my air compressors for air management/ compressors, the other for subwoofers.

This distribution block is very well built, and has a generous amount of internal space. I mention this because I am running Knukonceptz 1/0 awg in and 4 awg out power wire, and although it is the thickest 1/0 and 4 awg wire I've used, it fits easily without having to do the twist and push method. I would definitely recommend this block

good quality for the price

Bloque de distribución de buena calidad y precio