C2G Wiremold Floor Cord Management Kit, Corduct, Cord Protector, Wire Organizer and Hider, Rubber Cable Cover and Concealer, Gray, 5 Feet, CDG-5

Wiremold for protection of wires that need to cross foot traffic areas so that people do not trip over the wires. The construction of the wiremold is such that it prevents the slippage of the wiremold on the floor very well, though this is NOT adhesion. It has no Drying Power other than it may keep the cable from becoming saturated with water that may be spilled on the floor. The material is such that it appears to be very sturdy in protection of the wire on a high foot traffic area, and keeping it all safe.

I bought this product about 3-4 years ago and I am now reviewing this but would like to say that I have just came across some spare wire protective covers in my room and I needed some spare and would like to say that this product came in handy when my cats were kittens when they used to chew up my wires especially on my power strip, when I replaced my power strip I put this cover on and since then It protects my wires very well and even hides the cables well. It is very sturdy and sits well behind my desk without any issues after 3-4 years and still holds up to this date.

I've got 8 total wires ( 4 speakers ) going through it. It works pretty well. It's a little warp and you can always cut it to size if its too long.

We’ll have to buy another. That was so good.

Just like the headline says, it comes rolled up and is VERY difficult to get straightened out. I took a hot air gun to it for like 10 minutes before tripping a breaker and it still wanted to roll up. I had to leave it for a couple of days in the Arizona sun in the middle of summer for it to finally want to stay straightened out.Additionally, the included 2 sided tape is horrible. For semi permanent installation, I recommend getting some VHB or Gorilla Tape.

We purchased this protective strip to protect our copper fuel line feeding our burner. It is made with strong rubber construction that has a slit in the bottom making it easy to bend to open and slide our copper line inside to keep it safe. It leaves a very easy slope to step on and over with no damage to copper tubing. Very satisfied with this choice.

Rolled tightly to ship; have it hanging on rocker to flatten out. Going to protect the electrical cord from my husband's electric recliner!

The product arrived rolled up on itself. It was difficult to get to lay flat. I left it to flatten out for a couple of days, held flat by table legs. It is not easy to cut with a hand held blade. A miter saw would have maybe been better. It still wants to curl up on the ends once applied on a semi smooth (vinyl tile) floor, using the adhesive. Maybe it's the adhesive tape quality. I may hit it with the heat gun to see if it relaxes and lays flat.