Complete Serpentine Belt Drive Component Kit

Fit great and works great. Been using for over a year

This is a great product I have been a mechanic for over 25 years the heavy duty belts are spectacular and gates has great bearings in there pullys and tensioner i installed this belt set up on my 09 ram after replacing the water pump and fan clutch 8000 miles ago and have had absolutely no issues if you were to look at fleet vehicles alot of them run this system for a reason

Good value

Fit like it should. Just needed a 3/8 breaker bar, 13mm and 16mm and 3/8 torque wrench for the idler pulley at 20 ft lb. And 31 ft lb for the tensioner. Pulled belt out around the fan. I did out a 6" extension on the handle on the breaker bar since it had a spot for that. 30 minute job. No squeeks.

Installed this product everything fit great. Drove about 200 miles then i noticed a squeak when rpms where changing. Pulled over and noticed adjuster was stuck in the position needed to remove belt and the belt was loose. Limped truck home and took tensioner off. The end of the spring in the adjuster looked it was twisted out of the plastic retainer I would guess spring came loose inside adjuster. Luckily I saved the old adjuster a reinstalled it with the new belt. So far the new belt and idler pulley are working great. But I would not trust the tensioner.

Great product Gates has always been a leader with hoses and belts fit perfectly and runs seamlessly.

I can't attest to the longevity, only a few hundred miles so far but the timing belt and water pump fit correctly. (I pulled the motor to fix head gasket, and replaced belt and pump at the same time). Note: The engine in the Subaru automatic does not have the belt retention clip above the timing gear. I didn't know this, and ordered one, waited for it, and then found put I didn't need it.

I don't know about the longevity yet, the fit and installation was just like factory.