xiwai ATX Power Cable for Molex Micro Fit Connector 4Pin Male to 4-pin Male Power 12V Cable 60cm 20AWG Pitch=3.0mm

It’s a standard fit and worked well as a replacement cable for a 3D printer Kobra S1 feeder.

For those of you trying this for use with A1 and AMS Pro 2 you need to swap some wires with is really simple. If you look at the cable and consider the "top" to be where the locking clip is. The bottom yellow and black need to be switched on one end. I cut yellow and black in the middle rather than trying to swap pins and reconnected the cut wires. Is working perfect on my A1 with AMS Pro 2 and I'm using the P1/X1 buffer since I couldn't ever catch the A1 hub in stock. Works perfectly once those two wires are either swapped at the pin point on one side or you can splice them in the middle like I did and connect them to the other.

great replacement plug.

Didn’t work, bad cable. Tried to power ams hub to P1S, but the printer couldn’t detect the ams. This cable was the issue

These fit the PoE power input (54v) switches from HP/Aruba. A nominal 48v LFPO can provide direct power (fuse it), as they typically run between 52-54v.

Bought this for my Cradlepoint and it fits perfectly. The yellow is the 12v positive and the red would be the switched power if you want to wire it that way. There are 2 black wires one is negative and one is power out. I only used the Yellow and ground wire

Used this to plug some LED lights into my Bambu A1 printer. Worked perfectly.

You probably want the connector with the standard 4.2 mm pitch and row spacing. NOT THIS ONE. Otherwise it's fine, just uncommon.

I saw that somebody else wrote that it worked to connect some LED lights to a Bambu A1 printer. I just wanted to add, if anybody else will be looking for this info, that it also worked with a P1 printer.

proprio come in foto

Works great.