Side Rain Guards Wind Deflectors 6p for 2021 2022 2023 KIA Seltos

Fits perfectly - has a glossy finish.

I bought the rain guards for a 2021 Kia Seltos LX and they fit perfectly.

I've been installing these type of Wind Deflectors for about 20 years on Dodge RAM trucks, Ford F-150's, Kia Forte,Mercedes, and now this 2021 Kia Seltos. But there is a PROPER method of putting them on so they won't fall off or be blown off or even swept off in a car wash.Product Problem:1) The reason I gave it 4 stars is because the instructions are on the box and they are incomplete.2) There are no alcohol wipes with the product.3) The tape says it is from Korea and (may be good) but it's not the 3M brand who invented it. Also the 3M tape is used by vehicle manufacturers to tape on vehicle badges, bumper guards on doors, and more. Auto repair paint shops also use it. It lasts for years.4) There was NO Tape Primer included (see below for more info).How To Properly Install Like A Pro:1) Wash the vehicle.2) I use Windex (buy here on Amazon) to clean the surface the tape will be glued to because it has ammonia and will get off any residual soap or dirt/grime.3) Either use an alcohol pad (which should have been included), or use some isopropil alcohol and a paper towel to wipe down the area where the tape will glue the Wind Deflectors to. This not only promotes tape adhesion but cleans any ammonia from the trim area.4) Do a dry run with the Wind Deflectors and make sure they fit and you understand how to attach them before pulling off the tape backing.5) After the alcohol has dried, wipe the area with either 3M Tape Primer 94 or 3M 6396 Adhesion Promoter Attachment Tape Liquid Primer or 3M 4298 Adhesion Promoter (found here on Amazon). Let it DRY which takes just a minute or two.6) While the Tape Primer is drying peel about 3 inches of the tape backing off from the front and back of the 1st item you are putting on. Let the backing hang down where you can grab it as once you put the Wind Deflector onto the vehicle with the Tape Primer on it... IT'S GOING TO STICK VERY WELL AND CAN'T BE REMOVED!7) Place the front TIP of the Wind Deflector at the front of the vehicle and GENTLY press. Line up the rest of the Wind Deflector correctly with the vehicle and pull the tape off of the rear. Press it onto the vehicle. Now pull the rest of the tape from the Wind Deflector and use a paper towel or soft cloth to press (HARD) against the taped portion. I also use a small rubber wheel to get even more pressure.(8) There are 6 pieces in this kit so do this method with all six and you'll have years of beautiful trim on your vehicle which will withstand the wind, rain, snow, car washes, etc. You can also use the 3M Tape Primer or Adhesion Promoter on other taping projects you may have. It's WORTH it to buy it here on Amazon and use it to put on your Wind Deflectors.

They keep the rain out and it looks as if they came from the factory.

Got asa I ordered new ride it took over a month didn’t fit wrong year & too late to return

They are wonderful . It really improved the look of the car. The nice fact about them is they are flat to the window, so it looks like they were suppose to be there. I Love Them, well worth the money.

Just installed these on my '21 Seltos SX. They look great. Easy to install. Super tacky adhesive. I didn't find any installation instructions inside the box, but I happened to notice they are written on the box itself.

Came earlier than expected! Bonus. Just brought the guards easy to put on. I live on the Oregon Coast, We get more rain then sunshine so we will see in a few days how the hold up.