Silicone Speaker Isolation Feet (4-Pack, 1") – Non-Skid Adhesive Pads for Turntable, Subwoofer & Audio Gear – Anti-Vibration Damping, 20 Duro Rubber

Worked out great but actually used them for the bottom of my work cooler cause they don’t make rubber feet for it. If they ever need to be replaced I will definitely be buying another pack

Great product, fast shipping. I have ordered this product a couple of times and the quality is consistent

I installed a NAS device inside a cabinet in my entertainment system. The NAS device was sitting on a shelf which is suspended by these little pegs in the walls of the cabinet, which are themselves inserted into a metal track that runs inside a routed-out groove in the birch plywood wall of the cabinet. This was producing a rather loud hum that was annoying. I could tell the hum was coming from the vibration of the pegs, the wooden shelf, and the metal track. So I put a piece of unused carpeted floor mats from an old car under the NAS device. It didn't help a whole lot.I searched on Amazon for another solution and ordered these feet straightaway. They were easy to install, and reduced the hum in the cabinet by probably 90%. I should say the unit is still resting on the old floor mats, so the combination might make the difference, but clearly the feet went way beyond the carpet's ability to absorb the vibration on its own. We can barely hear the unit now — and then only when we stand in a certain place a few feet from the cabinet.We are very happy with this purchase.

Purchased this product to use as feet on a Silverstone Fortress FTZ01B-E HTPC computer case. Pads are adhesive and are very easy to install. Adhesive pads are high quality 3M and adhesion is great. Rubber durometer is pretty soft, which absorbs most of the vibration when case fans kick in (4). Pads are hemispherical and measure 1” wide and 1/2” tall giving plenty of airflow for bottom intake vents. Pads were purchased as a far superior replacement to the pads that came with the case. Silverstone needs to hookup with Hudson and make these standard. GREAT, HIGH QUALITY, PRODUCT made right here in the USA.

These do work. However, my Kanto Tuk speakers are front heavy (as many speakers are), and this squished the front nubs down much more than the back ones. (These nubs are pretty squishy). Not sure you can see it in the photos, but it was an issue. **ADVICE: if you have front heavy speakers, buy smaller domes for the back, bigger ones for the front. Right now I have .75” domes in back, 1” in the front. It is almost even now, with the front angling up just slightly —much better than angling down.If you want to angle them up even more for near field desktop use, do the same trick with even bigger domes at the front. Then no need for a separate tilting wedge/stand.

Me encanta la textura y como protege el subuffer. No siento cambios en las vibraciones, por lo que los efectos del sonido salen nítidos.

These are only about an inch in diameter. Somehow I thought they would be bigger. They seem to be working though so no problem.

Bough these to use for a small subwoofer install for my car. Wanted to elevate just a little so the sub wasn't sitting directly on the trunk of my car but wanted it to be stationary as well. These were the perfect size and allows me to position the sub where I want it in my trunk without it sliding around and not having to adhere the sub to my vehicle. Makes it very portable/removable if need be.