OREI 4K 1x8 HDMI Extender Splitter, Multiple Over Single Cable CAT6/7 4K@60Hz 4:4:4 HDCP 2.2 with IR Remote EDID Management - Up to 115 Ft - Loop Out - Low Latency - Full Support

We are using this to send digital signage content from a player out to 4 different TV's in a retail setting. According to a Fluke network tester, the furthest run was about 45 meters over Cat 5e cable. This device worked flawlessly. We are using it for 1080p content, no audio, and leveraging the POE functionality of this unit. Our previous sender system died and it required power adapters on all of the receivers. It was a much older OREI model. This new redesigned model is better because there are no power adapters needed on the receivers. The HDBitT transmission medium results in a pristine image, free of sparkles or artifacts that you can see on noisy, long run Cat 5e or lesser quality cable on some other solutions "proprietary" signal over twisted pair tech.So far so good, I recommend this unit for any commercial, retail or even a home setting where you want to send content from one source to up to 4 sources. It is 4k ready, has RS232 serial control as well as Digital and Analog audio extraction from the HDMI source - great features we don't need but you might. It has a convenient HDMI output so we are able to monitor the content from the network closet so we know a good source is being provided to the unit for sending out in the field.

Super easy install! Plug and play

UPDATE2: Received new replacement receiver. This seller came through!UPDATE: After an email exchange with the manufacture the failed unit will be replaced. Thanks for the communication.Purchased the 1x8 HDMI Extender Splitter June of 2022 and installed five of the receiver units when the product arrived.We held off on installing the sixth unit as we were doing a kitchen remodel where the sixth was to be installed. Once the remodel was completed it was installed but this was after the warranty period expired. After 2 months the unit failed. The picture would go black then back to normal and repeat. I swapped it with one of the original installed units and the problem stayed with the unit. So after two months of use the unit is defective.Even though it sat new in the box until it was installed and in use for only 2 months the seller will not replace it.Bottom line the seller will not stand behind their product that was in use for 2 months and went bad.Poor policy. Buyer beware!

Easy to set up. Works like a charm so far. Replaced my POS HDMI 4X4 Matrix with this one. Interestingly the picture is a whole lot better with the Orei. Would definitely recommend it.

I love these but the only downside is the audio lag to the satellite tvs

It works good when it works. I have purchased several of these in different configurations for work and they have all worked fine. The one I purchase for personal use, it is the one that each time I flip to the HDMI input and try to use it, it fails to come up. I end up having to reboot the unit each time. This is not ideal. I also had issues with screens flashing as well before they just up and quit. Of course the return window is up now so I can't even return the unit and go a different route.

Just arrived today. So far so good. It runs over a 100ft HDMI for input with no problem. Wireless puck input great quality running from my Samsung S24. Seems to be good so far.

This HDMI over cat6 matrix (210 foot version) has been working great for years. It's the most reliable video distribution method we have on stage.Everything else had occasional video corruption or dropouts. Even expensive dual link SDI gear had problems. This OREI HDMI over cat6 matrix just keeps humming along with the best consistent performance of anything we've used. (While always using edid emulators to keep HDMI resolution changing from causing chaos in the video system).Two thumbs up. Would buy again.