Nilight 8PCS Motorcycle RGB Led Light Kit Waterproof Multi-Color Atmosphere Lights Lamp with 4Key RF Wireless Remote for Harley Davidson Honda Kawasaki Suzuki, 2 Years Warranty (TL-42)

I ordered these to spice up my 01 Softail. Man what a great decision!! Took me about 15 minutes to figure out where and how I wanted to mount them. After that it was a breeze. There was enough wire included to do the install without having to buy and extensions. The lights are bright, these are just simple ones with preset lighting patterns and no app control, but perfectly fine just for that little bit of show. So far great product and worth the price.

I have done a few light kits now. 2 years ago, I put a kit on my brother's bike. It was ok. Then I bought a cheaper kit for my bike. It only lasted a month. My bro got a new bike so I put a light kit on it for him. It was this one. I was so impressed that I bought me one. I had to peel off my old kit. It looked awful. I don't remember the name of that kit but this new kit is so much better quality. The double sided tape sticks good. It works best when it's warm. All that tape is the same way though. I usually have the lights on when I install them. To make sure they are shining where I want. And it makes the lights alittle warm so they stick better. Plus I don't just stick the lights on and go. I will rub them bad and forth a little bit. Makes sure they are sticking good. I have yet to use the switch on a permanent light job but it seems to work ok. All the bikes I have put them on has had an open accessory switch. So I cut the original wires up. I cut the fuse off and reuse it and then wire it directly to a keyed and switches circuit. Which works pretty good. You can leave the switch on and they just come on when the bike is on. Or turn them on at dark like I do. And they save whatever you had them on last. If you got them on a solid color and turn them off, them come back on with the same solid color. If you got them on blinking and turn them off, when you turn them back on, they blink. And when you turn them on, they blink white twice before they start doing their thing. Some extra splits and extensions it a plus. Especially if you are going to run lights up to your front wheel. If you are going to light up a side by side, I would do 4 extensions. Then you could run 3 lights on all 4 corners. The lights also come with an "All lights red" wire when you hit the brake lights. I didn't hook it up permanently on anything but I did try it and it did work. On my bike I plan to mainly red so the red on brake thing wouldn't show up anyway. I do plan to get more of this lights. Accouple of my buddy saw our bikes and love the lights so I will most likely be putting these lights on their bikes too.

Works well, but the colors aren't quite as vibrant as advertised. Common rgb led issue. I do like the different modes and how much extra wire comes with the kit. Worked great on 2006 vtx1300

Very good

The media could not be loaded. This kit is great! I used CRC Dielectric grease on every connector.I live near the ocean so salt air is always an issue.I installed these on my 2021 Harley-Davidson Road Glide Special. Layed out a moving blanket. You'll need the wire extension kit they sell separately!Removed Seat, saddle bags, covers and fuel tank. Always pull the 50 Amp fuse when doing any electrical work on your bike!!! Start by laying out the LED strips and figure out how your going to have everything meet up at the battery. I used up some extra space near the antlock brake module to house the module for the lights and ran the wires to the battery.Took about 90 minutes.Used tie wraps for under the saddle bags and be sure to make note of the position of the underneath saddle bag bumpers. Tie wrap ends should be facing almost downward as to allow the bag to be reinstalled without an issue. Value for the money is great. Quality of the connectors and shrink-wrap used was proper for not allowing water in. Every connector not used was tie wrapped and tapped off for future use.I have two more that I just might add to the very underneath of the bike at a later time. For now, I'm happy with how they look.I highly recommend this product.The little key fob is perfect!

They are bright. Remote is okay.But they kill my battery constantly.... they turn on by themselves daily! It's got to the point that un-installed them for months. I need to wire in a switch, but on my superbike, room is hard to come by so I've been procrastinating. You would think since they are remote controlled, this wouldn't be a problem, but it is; a major problem at that.Fix that issue and these would be great for the price.

I’ll preface this review by saying that I have never done any wiring before or have any experience with electrical work and this took me about 2-3 hours to install. I haven’t used the app, but the Bluetooth remotes are nice. I stuck the keychain remote with adhesive underneath my left handlebar on the fairing of my R3 so I can turn it off/on easily. Tools needed were wire crimps/cutters, and your basic tools for removing fairings to run the wires easier. It is possible to run them without adding any extra wiring, just takes some brain power. The adhesive is super sticky but I used a few dots of superglue for extra peace of mind on the ends. Zip ties to hold wires in place when running them through the bike.I love these. I bought them primarily so I would be seen better at night, but the side effect is thumbs ups and head turns! Awesome! They’re bright as hell at night, and I even leave them on during the day because I have two strips mounted in the front so they act as daytime running lights.The only issue I’ve ran into is when I turn the lights “off” they tend to just turn to a dim green color. Luckily I caught it before they killed my battery. So to mitigate this I usually just disconnect them when I’m done riding for the night.Overall 9.9/10

Lights work as avertised however I wish the wires were a little longer it was a b word to run them overall good product so far