FIAMM5190512 Marine Horn with Stainless Steel Grill,1 Pack

I recently bough this FIAMM boat horn for my 19' Sea Pro, replacing the old one that gave out after the water-resistant membrane degraded and allowed water to seep in. That previous horn lasted about 5 years, so I’m hoping for similar durability from this one. I’m pleased to say that this new horn fit perfectly and looked just like the old one, except, of course, this one actually works!The stainless steel cover from the old horn held up well without rusting, but to be fair, I mostly boat in fresh water and only occasionally in brackish water. So, take that with a grain of salt (pun intended) and this might change now that I'm near the James River/York River. I’m hopeful that the new stainless steel cover will deliver the same rust-resistant performance and ASSUME that this one is made of the same steel. All that to say, its a horn and this horn meets the USCG requirements for a signaling device for this size vessel!Installation was easy for me, as I already had a cutout for the horn, and the electrical spade connections to attach it.The FIAMM horn is a great choice if you’re looking for a budget-friendly, straightforward replacement that gets the job done, hopefully for the next few years at least!

Replaced my original '99 Four Winns Horizon boat horn. It was not the original size so had to cut some fiberglass to make it fit.It was nerve racking to cut it since I didn't want to make it too big and the cover won't hide the hole. Just cut a little out each time to see if it fits. No rust from the cover or supplied screws and the horn work ok. Not super loud but it's legal now.

Bought this for a 2005 Crownline 225 Razor. It is a simple installation, easy replacement, price was reasonable and is loud.

Installed on our pontoon boat and worked well

This horn and SS cover appear to be well-made and it is a direct replacement for deck boat bow horn. Took hours to locate just the right size and shape and it arrived on time and in good condition. Highly recommend.

Replaced old horn that was not very loud. This one is very loud and was an easy replacement size

Perfect fit to replace the OEM horn on my Edgewater 245CX. Only problem is the OEM installation position on the boat does not meet the horn manufacturers requirements of mounting on a minimum 70' angled surface, Since the mounting surface is flatter, more like 45', it allows the horn to be filled with water which will eventually corrode the horn and need replacement again. If the first horn lasted 10 years, then I will likely be selling the boat before the end of the next ten years.

Easy to install