Lot of/ 5pcs 5Pin Cable Replacement Arcade Wiring Cable For Sanwa Joystick Zero Delay USB Encoder 5-Pin Rocker Wire Pitch 2.54mm JST XH Adapter

For some reason, one of my Sanwa sticks stopped working in my arcade cabinet. I honestly had the thing in bits looking for the reason. It couldn't have been the cable because it's solid state and has no moving parts. Right?Wrong, upon very close examination under a magnified lamp, it became apparent that one of my existing wires was damaged at it's termination point. Rats. I ordered this set of replacements and they arrived quickly and well packaged. The cables were literally hot-swapped with the old ones and I was up and running again. Perfection. As this is a pack of five cables, I can safely say it will be some years before I need to buy any more! Totally recommended.

Great value for a set of four though you'll likely only ever need one.Connect one end to the Arcade Stick and the other to the 5 pin connector on the board.No soldering required and the connectors are already installed so no crimp tool or cable required whatsoever.Top tip : if you have installed your new stick and find that only one direction is working (usually up) simply unplug and flip the connector that connects to the stick over and then reconnect it, and it should then work fine.

Just great.