2 in 1 Mitre Measuring Cutting Tool- Miter Saw Protractor Measuring and Sawing Mitre Angles Cutting Tool Corner Clamp 85-180°Angle Measuring Tool for Home Improvement Carpentry Work

Good product

Easy to use. Works well.

Easy to line up for exact corners and lock into place. You will need something to hold your board in place like an old rubber stopper but very secure once it's locked in. Simple design, does exactly what it says it will.

ok, i didn't think about this before it bought it.there is no easy way to secure the tool to a workbench or secure wood to tool.i used a c-clamp in wood cutting channel to hold down tool. it worked for shoe molding but wood size may interfere with clamp. place the tool across a corner to place clamp on either side of bench. angle pointing toward corner.feet could have been added for clamping or better yet, feet with predrilled holes to secure to workbench.also it could use a clamping means or clamping support for the wood being cut.that saves two hands.it's the little things that count.john abbott

Not able to return this, as I failed to notice the 30 return window. I didn't open the package until I was ready to use the device. The rubber stopper was not in the box. That holds the item to be cut in place. No way to go to third party to request the stopper. Tried using the mitre 2 in 1 without rubber stopper but not possible, plus the uprights are not long enough for most base boards.Lesson leaned. Open package upon receiving and pay attention to return dates.

I purchased this product to help make cuts for baseboard unusual corners. Product easy to use. It is lightweight and does a great job.

Very happy with the interesting tool!! It works!

OK, PRODUCT IS CHEAP, BUT LOOK WHAT YOU PAID FOR IT, SO?YOU CAN LINE YOUR BASE BOARD BUT THE" METAL GUIDES" ARE TOO LOW AND WHEN THE WOOD IS PLACED IN THE GUIDE, ( HOLDING IT THERE IS ANOTHER PROBLEM WHILE CUTTING) THE WOOD IS HIGHER THAT THE GUIDE POLES SO, A PRE CUT LINE WAS MADE WITH THE HACKSAW, JUST TO GET THE ANGLE NEEDED TO CUT, THEN I BROUGHT IT TO THE TABLE SAW FOR ITS CUT USING THE PRE ANGLE CUT AND IT WORKED OUT PRETTY NICE, nOTE; UsE iT aS gUIDE fOR yOUR rEAl CuT oN tHE mITER sAW.