Combo of 1" Diameter Low Profile Rifle Scope Rings Picatinny Mount System with M38, M39 and M44/Mosin Nagant 91/30 Scope Mount Picatinny Rail

This feels very sturdy, doesn’t wiggle once you set all the screws to desired elevation of the rail. I will say the machining is not perfect but only cosmetic wise, and in no wise effects the function of the accessory. My only gripes are the screws used to replace the pin on the rear site should be steel due to them being the only true thing holding the mount to the rifle itself, and also the rail itself if you want 100 percent rigidity and no flex when trying to set the elevation screws. Aluminum has a tendency to flex being a softer metal, which will cause a problem when holding zero after several rounds. Other than that, you get what you pay for at such a reasonable price, and it works exactly as advertised. Look no further for the rail. As for the scope I did not buy it so I can’t speak to it.

The picatinnny rail mounted easy enough but when I attached my optics I ended up with about an 18 inch eye relief. Normally, it should be about 3.5 inches. Now I'm shopping for a rail extension to get the optics closer to my eye.

I was a bit skeptical because of the low price. But ordered it anyway. My stock mows and rear sight was impossible to remove so my only option was the style of mount. I had it installed leveled and ready to go within 10 to 15 minutes. solid as could be with no movement. I am pleasantly surprised.

It worked perfectly, and is extremely solid. I put 40 rounds down range with a scope mounted to this, and everything stayed in place. If you are looking for a mounting system that is quick, easy, and less than the cost of the rifle itself, I highly recommend this.

The scope is advertised as a long eye relief scope. I had to be less than 2 inches away from the glass in order to see through it. The mount is somewhat adequate but you're getting what you pay for.

If you want to put a scope on your mosin temporarily.

Perfect fit on the 1943 Mosin Nagant.

Item was too wide to fit in the intended place. After removing .0905" from each side with an end mill I made it work. Product was also supposed to come with a 7.62 bore laser with a rim. It came with a 7.92 (8mm) rimless bore laser. Luckily I have both chamberings.