JENOLITE Rust Converter Spray | 500ml | Fast-Acting Epoxy Based Rust Treatment & Inhibitor for Metal | Converts Corrosion into a Stable, Ready-to-Paint Surface

Excellent product, easy to use and works quickly. I was previously sanding off rust by hand prior to painting and this has saved me a vast amount of time. Pictured is a carriage pole I am refurbishing, tested area on the left, untreated on the right. I will be buying it again!

This is a great product. I recently used it to treat the underbody of my 20 year old Ford Focus. It provided excellent coverage, and a good surface for paint to adhere to. However, as always with any type of paint/protector product, the preparation is every bit as important as the product itself. First, use a wire wheel and/or sandpaper to remove all the loose rust and dirt. Then use brake cleaner and a cloth to thoroughly clean and dry the area, and remove any grease. Only then should you apply the rust converter spray. Under these conditions, the spray adheres well to the surface, and forms an impenetrable epoxy barrier which stops rust developing further. Once this is dry, you can then paint it with the colour of your choice.

Good quality spray. Can make metal go black on contact.

After a bit of research into what product was best for my needs, I opted for Jenolite Rust Converter Spray. Stone chips had broken through the paint around the arch areas of my campervan, looking unsightly. A quick rub down on the affected area with 80 grit oxide paper back to clean metal, masking tape applied to avoid any overspray, then follow the instructions on the can - shake contents for a few mins, then apply from around 25cms, leave to dry circa 15 mins, then re-apply. It's clear initially, but as it gets to work it turns black, after 2 coats a thick protective layer is formed, after fully dry / cured the epoxy feels tough and has good coverage, I'm letting it fully harden over this week, and will look to apply a top coat of colour matched spray paint, and clear lacquer top coat to blend it in, and will then apply 2 coats of the Jenolite on top of the colour matched spray paint for added protective layer as it is clear. Good product, good performance straight out the tin with minimal prep, instructions are simple to follow.

After removing top rust and spraying Jenolite on and leaving over night to dry under the chassis looked really good ,even better when I sprayed it with the Jenolite satin spray .

This Jenolite Rust Converter Spray is really good. I was surprised how fast this spray worked on my rusty Ford Fusion underneath. You don't really have to paint any underseal paint on top of it, but i always make my special mix of paints and black gasket sealant mixed up with some paint thinners, works a treat everytime. I strongly suggest you wear protective glasses, face mask, gloves and some old clothes before you start painting. Try to remove all the bad rust, either with a good wire brush or one that fits to a drill or grinder. Remove all grease and dirt before spraying the Converter Spray. This isn't cheap stuff but it does the job on any rusted item's. Rust is just like a 'Cancer' it spreads if untreated. Always look after your vehicles and they will last for years. I highly recommend this "JENOLITE RUST CONVERTER", Just a shame it's so expensive..Absolutely brilliant stuff, it's the best rust converter i have ever come across. "5+STARS" From me. Will definitely be buying again, just hoping the delivery person doesn't leave it on my front door step, it's a very rough estate i live on, rob anything here in "WHITECROSS" Warrington...

Good product , delivered quickly . Time will tell if the rust is contained . Used this product in my youth and it worked well then .

Easy to apply. Fast drying and works well. Great coverage per can. For reference I did two coats on all rear suspension and rear floor pan of a vw Tiguan with 2 1/2 cans