Creality Original Ultra Removable Magnetic 3D Printer Build Surface Heated Bed Cover for Ender 3/Ender 3 Pro/Ender 3 V2/Ender 3 V2 Neo/Ender 3 Neo/Ender 3 S1/3 S1 Pro/Ender 5 Pro 3D Printer 235X235MM

Good

Met expectationd. The pods are expensive

Looking forward to upgrade my stock bed with this magnetic bed!

Fácil de instalar, quedo exacta a mi ender 3 V2, con este aditamento te olvidas de estar poniendo fijador de cabello a la plancha, y se retiran muy rápido, aún me faltan probar varios materiales, pero con PLA funciona muy bien,

Magnes bardzo słaby, ledwo trzyma się stołu za to wydruki trzymają się tak mocno że trudno je oderwać. Moim zdaniem to nie jest oryginał.

Garantisce un'ottima aderenza dei pezzi al piatto e soprattutto un facile distacco

I bought a glass build surface awhile back, and effed it up because my nozzle was set too low. If the spongy surface on the glass bed is scratched, it ruins it. So I got one of these magnetic ones, and it's a big improvement over both the glass and stock build plates. One thing I noticed is that it's very difficult to remove prints if you set the print bed temp. at 60 degrees, but prints come right off if you set it at 50 degrees C or below very easily. Another thing to note is that both of the pieces—the magnet and print bed—are both made up of smaller, rectangular magnets; neither is made of just metal. Because the magnets on both sides are rectangular, you can run into an issue where you stick the magnet down to the print bed, and go to lay the top sheet on it, and it won't line up exactly with your 3D print bed surface. There will be like an extra 1/4" of either underhang or overhang on the left or right. But the top surface itself is larger than the stock build plate, so you can also cut it to size if you prefer. I ran into the issue where if I let the top surface overhang on the right, it bumps against the power supply enclosure. So, I leave it with like 1/4" overhang on the left side of the plate, no big deal. It's so much better than holding down your print surface with binder clips. And the magnet is extremely flexible. Prints tend to peel right off, so long as you keep the bed temp. at 50 degrees C. I will say that they're near impossible to peel off if the bed is set at 60 degrees, and I can't emphasize this difference enough.