PAUTIX 10mm Connectors for CCT COB LED Strip Light 3 Pin Solderless Terminal Extension Connection Kit,4pcs Dual End Extension Connectors,2pcs Strip to DC Plug Extension Wire,4pcs Gapless Connectors

The media could not be loaded. Quick and easy connections, quality feel, reasonable price, every connection I made worked first time. This allowed me to go from shelf to shelf without much work. It was easy to hide the wires too.

Works on more than just Patix products. A bit fragile so connect with care.

These do not work. It creates a very unstable connection that even if it passes power, it changes the color or creates a flicker to the rest of the COB strip

I bought these because I was purchasing a Pautix COB USB light strip for bias lights. This was my first experience with any type of light strip so I kinda just bought what Amazon suggested. I’m happy I did. These 90° corners aren’t rigid but aren’t floppy. I guess you could say they’re firm. It really allows for a clean looking installation.

The kit works as intended. Nice that they use a clamp design that isn't permanent, so that if you need to reconnect it, you can just open it up (by pulling the side tabs apart to release the lock) and reconnect as needed.This was one of the few items I found that would convert from 4-pin to 10mm CCT, which was helpful for using 4-pin extenders.

This was my first try at using LED Strip lighting so my ignorance was vast! I purchased the 5 meter COB Tunable CCT strip light for $20 as well as their PAUTIX 10mm Connectors for CCT COB LED Strip Light 3 Pin Solderless Terminal Extension Connection Kit which was $10. Long story short, I invested about 5 very frustrating hours and used up half of the parts in the Pautix Connection Kit before I achieved "First Light"!My first mistake I made which cost me about 4 of those five hours of frustration was in assuming that the Pautix Light Strip and the Pautix Connection kit should provide me what I needed to connect to a 24 VDC power supply I purchased which had two screw terminal outputs. That assumption was wrong, neither the light nor the connection kit that I ordered came with the connector that mates with the connector that is installed on the lighting strip at the factory. After watching many videos and searching many "how to" articles I finally took a scissors and cut the factor connector off of the Pautix Strip (wasting a couple of centimeters of my 5 meters but worse, four hours of my time). It appears the only way to get the correct mating connector from Pautix is to order one of their controllers! Once I embraced that imbecilic truth, things went fairly fast.Most of the final hour of struggle occurred because I did not realize that there are actually two types of the small plastic clamp connectors that are included with the Pautix Connection Kit. I came to think of them as the "right hand" and "left hand" connectors and you need to be using the correct one depending on which end of the light strip you are attaching to. Had these two pieces of information been clearly stated in the instructions, I would probably had "First Light" with an hour!!!All that being said, once it was up and working I was very impressed with the amount and tunability of this product. It is very bright (if you need it). The self adhesive backing seems to be working quite well (although time will tell on that).

Bought some to help me wire lighting in a bookcase, worked great for CCT strips that have (3) leads.

Make sure you want 10mm and not 8mm