Illuminate Your Drive! 💥
The AKKON Driver Left Side Headlight is a brand new, direct replacement part designed specifically for 2007-2009 Altima 4-door sedan models with halogen headlights. This waterproof headlight features a sleek chrome finish and is engineered for a seamless fit, ensuring your vehicle shines bright while maintaining its aesthetic appeal. Professional installation is recommended, and it comes with a limited 90-day warranty for added assurance.
| Brand | AKKON |
| Color | Chrome |
| Specific Uses For Product | Head Lights |
| Vehicle Service Type | Car |
| Year | 2007 |
| Special Feature | Waterproof |
| Auto Part Position | Front Left |
| Lens Color | Clear |
| UPC | 840960192168 |
| Manufacturer | AKKON |
| Item Weight | 24.1 pounds |
| Package Dimensions | 27.25 x 13 x 10.75 inches |
| Manufacturer Part Number | 5-HD-JH-NA07-OE-L |
| Special Features | Waterproof |
S**E
NICE HEADLIGHT
LOOKS GREATM. FIT PERFECTLY. WASNT LOOKING FOR MUCH MORE.
A**R
Affordable price
Easy to find out if it’s fits my car before purchasing
E**N
Look better than stock
They look great, I like the blacked out background goes with the car nicely. I didn't expect to spend more than $100 because my old headlights are foggy but it looks good.
M**E
Halogen headlight
Very easy to install.
S**L
Good cheap aftermarket replacement- how to adjust after install
It went on pretty easy, but like another review mentioned I had to swap the clip for the screw on the bottom mounting tab (the new one is too big). I was able to change the headlight by removing the grill (plastic clips) and one screw behind the fender well liner where the fender and bumper come together. I was able to pull the bumper out far enough to get the bottom screw. There is a bundle of wire clipped to the headlight around the bottom that was a little frustrating to get off.After installing, the beam was pointed down real low. The adjustment knob is not at all like OEM so to adjust:Turn the tires to the opposite side to get room (see pic for driver side wheel turned), remove the 3 screws in the bottom of the bumper holding the front of the fender liner (see small phillips screws in pic). Remove the one plastic retainer clip that holds the fender liner corner to the engine splash shield. Inside the fender, pull the liner out of the way and you have access to the back of the headlight (also easy to change bulbs). I used an 11mm wrench on the knob to adjust the light (I believe it was counter clockwise to raise the beam). It's in a bad location so I did it mostly by feel, but you can see it. I installed the headlight during the day and adjusted it as it was getting dark. Drove around and it looks fine, I'm happy. Didn't have to jack the car up either.
B**E
great price fit.
very good fit & exactly as original.
A**N
Nice product, works like it should
Product as described.. wished it included lights though
J**F
Started off ok
First the pro. They fit well.Cons - Poor construction and poor customer serviceShortly after installing them, the passenger light began collecting a lot of condensation and water due to, what I suspected to be a leak in the seal. I contacted customer support and they replied quickly with some possible fixes which included checking the bulb connections and completely separating the lens from the body to dry it off and then reseal it. The bulbs were in tight and condensation continued to form and I dumped out quite a bit of water because taking the lens off wasn't going to happen.About the same time the drivers side light stopped adjusting. Came to us pointing 20 feet in front of the car and does not adjust upward. I have emailed them twice about this issue and am still waiting on a reply.
Trustpilot
2 weeks ago
3 weeks ago
