BOVKE Carrying Case Compatible with WALABOT DIY 2 - Advanced Stud Finder and Wall Scanner, Imaging Sensor Case for WALABOT in-Wall Imager with Mesh Pocket for Cables, Black

I have a walabot diy2 and I it was getting beat up in my tool bag. I replaced the cord twice and all kinds of grit would stick to the adhesive gel that attaches it to your phone. As soon as I saw this case I snatched one up. It has two zippered mesh pockets to hold the cord and some extra adhesive pads. It’s soft sided but fairly rigid. It seems very well protected. It is very compact and does not take up to much room in my tool bag.

This carrying case fits my WALABOT DIY 2 just fine but the case is about twice as tall as it needs to be. Length and depth are perfect. It is approximately the same size as the original box. The issue is the height. It literally could be half the height which would fit my tool bag and tool belt pockets much better.The case has a spot for the WALABOT that is protected by gel bubbles which is nice. Once you place the WALABOT in that space, there is a flap that goes over it and secures with Velcro. The picture on the product page shows memory cards stored in two of the pockets on one side. The WALABOT doesn't use memory cards so there really isn't a use for those pockets. On the other side of the flap (the part that rests on the WALABOT, there is a single pocket that you could use to store the USB charging cable. There is also a zipper compartment in the upper half of the case where you can store the charging cable and power adaptor if you choose to add your own. (The WALABOT only comes with a charging cable.) The whole upper half of the case could be eliminated if you are just storing the cable that came with the WALABOT.The case came in a thin plastic bag so it was a little crushed. It should really have been packed in a box. The craftsmanship of the case is a little sloppy.I'm not a fan of the extra flap with mesh pockets. It's kind of in the way and it's one more thing I have to deal with when removing or placing the WALABOT in the case. It doesn't serve a purpose other than to keep the WALABOT from flopping around in the case. If the case wasn't so tall, it wouldn't be an issue.This case is much cheaper than the OEM case so you'll need to decide if the larger case is a showstopper for you.