Creality Official K1C Build Plate PEI Sheet with Nozzle Cleaner, 235x235mm Smooth Surface Flexible Removable Spring Steel Platform for Ender 3S1/3S1 Pro/3V2 Neo/3V3 SE/KE K1(No Magnetic Base)

Great adhesion, MUCH better than the stock coated plate. The outer box said some odd size but inside the plates were the correct size for my E3 v3 KE.

Build plate works well. For at least the first few prints. Haven't had to skirt or raft my prints yet as they have adhered to the plate well. Plate is flexible which helps to take off the print when complete. Great replacement for the OEM plate that came on the Ender V3.

It works great.

initially had trouble with adhesion as they are ultra slick, but necessary for PETG removal. A little glue stick solved the adhesion issue. great for getting your project off the bed

The print quality has definitely improved. A baby can install it, and it looks sleek and awesome. Well done Creality

This makes projects much easier to remove, and much less worry about breaking anything. Also easier to keep the mat clean, and ensure your bed is level.One note, be sure to heat up the bed when sticking the bed side magnet, and don't follow the directions that come with this. The directions have you attach the mat to the bed magnet, and then stick it to the bed. Worst idea ever, just make sure you have the correct orientation, heat up the bed, and start from one side and have a flat straight edge to gradually and smoothly apply the stick on magnet and remove bubbles as you go. Be sure to level the bed afterwards.

Very nice product

I assumed buying from the maker of my unit would be best. I got my Elder 3V2 used and it came with a branded magnetic pad with no wear or signs. Printed over 20 mid to large files, I tore the Matt with a blade so ordered a 2 pack since I’m still learning. They came in fully sealed but after opening the box one of the two had the magnet sticky pad stuck to the pads bottom. I didn’t need the sticky side since my initial already had on, used a heat gun to remove the sticky. The pad had no signs of wear but had some discoloration from the other. I got 3 prints “small” and they had a hard time sticking to the pads bottom for first base prints. I installed the second one “and it gave me 12 so far but the base prints are starting to pop mid print? Everything is balanced and had someone come check it out and told the pads are not holding like they should. We put original one back on and print in the un-torn area and prints are still great??? Tossed these so I wouldn’t use them again. WASTE!!